Odyssey LX V6-3.5L (2000)
Is there continuity?
YES - Test the rear heater-A/C main switch and the rear heater-A/C passenger's control panel. Replace the switch as needed.
NO - Repair open in the wire between the rear mode control motor relay and the rear heater-A/C main switch, or between the rear mode control
motor relay and the rear heater-A/C passenger's control panel.
Rear Mode Control Motor Test
Rear Mode Control Motor Test
1. Disconnect the 7P connector from the rear mode control motor.
2. Connect battery power to the No.2 terminal of the rear mode control motor, and ground the No.1 terminal. To avoid damaging the rear mode
control motor, do not reverse power and ground.
3. Using a jumper wire, connect the No.1 terminal individually to the No.3, 4 and 6 terminals in that order. Each time the connection is made, the
rear mode control motor should run smoothly and stop. If the rear mode control motor does not run when jumping the first terminal, jump that
terminal again after jumping the other terminals. The rear mode control motor is OK if it runs when jumping the first terminal again.
4. If the rear mode control motor does not run in step 3, remove it, then check the rear mode control linkage and doors for smooth movement.
-
If the linkage and doors move smoothly, replace the rear mode control motor.
-
If the linkage or doors stick or bind, repair them as needed.
Climate Control
Recirculation Control Motor Circuit Troubleshooting
1. Check the No.3 (7.5 A) fuse in the driver's under-dash fuse/relay box.
Is the fuse OK?
YES - Go to step 2.
NO - Replace the fuse, and recheck.
2. Disconnect the recirculation control motor 7P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between the No.1 terminal of the recirculation control motor 7P connector and body ground.
Is there battery voltage?
YES - Go to step 5.
