Odyssey LX V6-3.5L (2000)
11.
Apply a small amount of grease to each switch pin on the B-pillar.
12.
Turn the main switch off, then close and open the door manually. Verify the junction switch alignment by checking the B-pillar side of the switch:
Each switch pin should have a small grease dimple in its center.
13.
If the grease dimples are not centered on every pin, adjust the junction switch as necessary.
14.
Use contact cleaner on a clean shop towel to remove the grease from the junction switch pins and contacts.
NOTE:
All junction switch pins and contacts must be tree of grease. Failure to thoroughly clean them may create more power sliding door problems.
15.
Repeat steps 3 thru 14 on the other power sliding door.
*16. Write down the radio station presets.
17.
Disconnect the negative cable from the battery. Failure to disconnect the negative cable may damage the power sliding door control units.*
18.
Remove the left and right B-pillar trim pieces. Refer to page 20-56 of the 1999-00 Odyssey Service Manual.
19.
Check whether G551 and G581 have star washers between the ground terminal and the body.
^
If they have star washers, go to step 26.
^
If they do not have star washers, go to step 20.
20.
At the left B-pillar, locate and remove the ground bolt for G551.
21.
Use sandpaper to remove the paint around the ground bolt hole.
*22. Clean the paint out of the ground bolt hole by running a 6 mm x 1.0 tap through the hole.*
