Odyssey LX V6-3.5L (2000)
5. Reconnect the driver's multiplex control unit to the fuse/relay box, and perform the following input tests at the appropriate connectors on the back
of the fuse/relay box.
-
If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, go to step 6.
6. Remove the driver's door panel, and disconnect the 20P connector from the door unit.
7. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK. go to step 8.
8. Reconnect the connector to the unit, and make these input tests.
-
If a test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the control unit must be faulty;
replace it.
9. If all the input tests prove OK, one of the control units must be faulty. Substitute a known-good control unit for the one that is most likely at fault,
then recheck the system. If the system works properly, the original control unit is faulty; replace it. If there is still a malfunction, substitute a
known-good control unit for the next most likely unit to be at fault, and recheck. If the system works properly, the original unit is faulty; replace it.
