Odyssey LX V6-3.5L (2000)
1. Remove the terminal.
2. Go to HOW TO INSTALL NEW TERMINALS.
EXAMPLE G:
1. Remove the terminal.
2. Go to HOW TO INSTALL NEW TERMINALS.
How to Install New Terminals
1. Carefully match the old terminal with a new one from the terminal repair kit. Choose the correct replacement terminal based on the wire size range
the terminal will accommodate.
NOTE: If the replacement terminal quantities are low, reorder them by using the terminal part number listed on the inside lid of the terminal
repair kit. Replacement terminals are available through your parts department using normal parts ordering procedures.
2. Depending on the size of the wire you are repairing, use the proper size slot in the crimping tool.
3. Strip the insulation off the end of the wire so the wire fits in the new terminal as shown. (If the wire has a wire seal, replace it with a new one from
the kit.)
NOTE: After stripping the end of the wire, make sure you did not cut any wire strands. If you did, cut the wire off even with the insulation, and
strip it again.