Odyssey LX V6-3.5L (2000)
Repairs and Inspections Required After a Collision: Service and Repair
COMPONENT REPLACEMENT/INSPECTION AFTER SRS DEPLOYMENT
NOTE: Before doing any SRS repairs, use the HDS method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious
deployed parts (seat belt tensioners, front sensors, side airbag sensors, etc.).
After a collision where the front airbags deployed, replace these items:
-
SRS unit
-
Airbags
-
Seat belt tensioners
During the repair process, inspect these areas:
-
Inspect all the SRS wire harnesses. Replace, don't repair, any damaged harness.
-
Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
After the vehicle is completely repaired, turn the ignition switch on. If the SRS indicator comes on for about 6 seconds and then goes off, the SRS
airbag system is OK. If the indicator does not function properly, use the HDS to read the DTC(s). If this doesn't retrieve any codes, use the Tester's
SCS menu method. If the SCS method doesn't work, you may need to install a known-good SRS unit to read the DTC(s). If you still cannot retrieve a
code, go to SRS Indicator Circuit Troubleshooting.
AFTER A VEHICLE COLLISION
After the vehicle is completely repaired, turn the ignition switch on. If the SRS indicator comes on for about 6 seconds and then goes off, the SRS
airbag system is OK. If the indicator does not function properly, use the HDS to read the DTC. bag system is OK. If the indicator does not function
properly, use the HDS to read the DTC.