Odyssey LX V6-3.5L (2000)
13. Insert the brush (A) into the brush holder, and bring the brush into contact with the commutator, then attach a spring scale (B) to the spring (C).
Measure the spring tension at the moment the spring lifts off the brush.
14. Pry back each brush spring with a screwdriver, then position the brush about halfway out of its holder, and release the spring to hold it there.
15. Install the armature in the housing. Next, pry back each brush spring again, and push the brush down until it seats against the commutator, then
release the spring against the end of the brush.
NOTE: To seat new brushes, slip a strip of # 500 or # 600 sandpaper, with the grit side up, between the commutator and each brush, and
smoothly rotate the armature. The contact surface of the brushes will be sanded to the same contour as the commutator
16. Install the starter end cover (A) to retain the brush holder (B).
Overrunning Clutch Inspection
