Odyssey LX V6-3.5L (2000)
23. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tool, and a press. Place the wheel
bearing on the knuckle with the pack seal side facing (metal color) toward the inside. Be careful not to damage the sleeve of the pack seal.
24. Install the circlip (A) securely in the knuckle (B).
25. Install the splash guard (C), and tighten the screws (D).
26. Install the hub (A) onto the knuckle (B) using the special tools shown and a hydraulic press. Be careful not to distort the splash guard (C).
27. Install the knuckle in the reverse order of removal, and pay particular attention to the following items:
-
Be careful not to damage the ball joint boots when installing the knuckle.
-
Torque all mounting hardware to the specified torque values.
-
Torque the castle nuts to the lower torque specifications, then tighten the only far enough to align the slot with the pin hole. Do not align the
castle nut by loosening.
-
Install new clips on the castle nuts after torquing.
-
Raise the locking tab on the spindle nut, then remove the nut.
-
Before installing the brake disc, clean the mating surface of the front hub and the inside of the brake disc.
-
Before installing the spindle nut, apply a small amount of motor oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
