Odyssey LX V6-3.5L (2000)
17. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of adhesive
(A) around the edge of the glass (B) as shown. Apply the adhesive within 30 minutes after applying the glass primer. Make a slightly thicker bead
at each corner.
18. Use suction cups (A) to hold the sliding door glass over the opening, align it and set it down on the adhesive. Lightly push on the sliding door glass
until its edges are fully seated on the adhesive all the way around. Do not open or close the doors until the adhesive is dry.
19. Scrape or wipe the excess adhesive off with a putty knife or towel. To remove adhesive from a painted surface or the rear window, use a soft shop
towel dampened with alcohol.
20. Let the adhesive dry for at least 1 hour, then spray water over the sliding door glass and check for leaks. Mark any leaking areas, let the sliding
door glass dry, then seal with sealant. Let the vehicle stand for at least 4 hours after sliding door glass installation. If the vehicle has to be used
within the first 4 hours, it must be driven slowly.
21. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following things for 2 to 3 days:
-
Slam the doors with all the windows rolled up.
-
Twist the body excessively (such as when going in and out of driveways at an angle or driving over rough,uneven roads).
