Passport 4WD V6-3.2L SOHC (6VD1) (1994)
/Page-1118001.png)
Brake Proportioning/Combination Valve: Testing and Inspection
Electrical Circuit Test
Electrical Circuit Test
1. Disconnect the wiring connector at the combination valve.
-
Connect a jumper wire from the harness to ground.
2. Turn the ignition key to "ON".
-
The warning light should light.
-
If the lamp will not light check the bulb.
3. Turn the ignition off.
-
Disconnect jumper wire and connect the harness to the switch terminal.
