Passport 4WD V6-3.2L SOHC (6VD1) (1994)
Valve Cover: Service and Repair
Right Hand Side
REMOVAL
Preparation: Remove battery ground Gable
1. Common chamber See: Intake Manifold/Service and Repair
2. Ventilation hose
-
Disconnect from cylinder head cover.
3. Fuel hose
-
Disconnect feed and return hoses from fuel pipes.
-
Remove two fuel hose fixing bolts on the cylinder head cover.
4. Engine hanger
-
Remove heat protector on exhaust manifold.
-
Remove bolts and nuts that secure the hanger to the exhaust manifold and cylinder head.
5. Heater pipe
-
Remove heater pipe fixing bolts from the bracket.
6. Cylinder head cover
-
Remove 11 fixing bolts, then the cylinder head cover.
INSTALLATION
6. Cylinder head cover
-
Clean the sealing surface of cylinder head and cylinder head cover to remove oil and sealing materials completely. Apply sealant (TB-12O7B
or equivalent) of bead diameter 2- 3 mm to four places of arched area of camshaft brackets on front and rear sides. (Fig. 6A1-5)
-
Tighten Cylinder head cover bolts to torque of N.m (lb.in) 8 (69)