Passport 4WD V6-3.2L SOHC (6VD1) (1994)
5) Turn the crankshaft counterclockwise to remove the belt slack between the crankshaft timing pulley and the RH bank camshaft timing pulley.
6) Install the belt on the water pump pulley.
7) Install the belt on the idler pulley.
8) Align the alignment mark (white line) on the timing belt with the alignment mark on the LH bank camshaft timing pulley. If the belt is difficult
to install turn the camshaft pulley slightly counterclockwise.
9) Install crankshaft pulley temporarily and tighten center bolt by hand (do not use a wrench). Turn the crankshaft pulley clockwise to give some
slack between the crankshaft timing pulley and the RH bank camshaft timing pulley.
10) Install the pusher while pushing the tension pulley to the belt.
11) Pull out the pin from the pusher.