Passport EX 2WD V6-3.2L DOHC (6VD1) (1998)
/Page-2368003.png)
8.
Apply lithium dielectric grease to the wire splice. Attach the splice to the red/white wire about one inch from the light.
9.
Cut two 500 mm long strips of EPT Sealer 3T (see REQUIRED MATERIALS). Cut the strips to make four 500 mm x 50 mm pieces.
10.
Remove the plastic backing from the EPT pieces, and fold them around the power wire as shown.
11.
Apply lithium dielectric grease to the power wire connector. Connect the power wire to the wire splice.
12.
Wrap a foam pad around the connection.
13.
Route the power wire through the sheet metal opening, across the top of the left speaker area, then out the opening at the rear pillar.
14.
Connect a long piece of lead wire to the power wire with vinyl tape.
