Passport EX 2WD V6-3.2L DOHC (6VD1) (1998)
3.
Apply a 1/2-inch-diameter dab of 3M Black Super Silicone Sealant into the recess in the back of the replacement fender molding.
4.
Remove the tape strip from the fender molding, and carefully attach the fender molding to the fender, starting at the fender's rear edge. Make sure
that the fender molding lines up with the adjacent front door molding.
5.
Use 3M General Purpose Adhesive Cleaner to remove any excess sealant.
6.
Tell your customer to allow at least 24 hours for the sealant to cure before washing the vehicle.
Disclaimer