Passport EX 2WD V6-3.2L DOHC (6VD1) (1998)
/Page-2128005.png)
11.
Route the lead wire through the retaining slot, then press the grommet all the way into the slot.
12.
Connect the coil lead wire to the thermo switch lead wire. Make sure the terminal insulators on both wires cover the terminals.
13.
Push any slack in the coil lead wire away from the coil through the grommet. Then, behind the retaining slot, firmly attach a mini wire tie around
the wire, and cut oft the excess wire tie. The wire tie prevents the wire from sliding back through the grommet and contacting the pulleys.
14.
Reinstall the inner fender mud flap.
15.
Reinstall the wheel, torque the lug nuts to 118 Nm (87 lb-ft), then lower the vehicle.
