Passport EX 2WD V6-3.2L DOHC (6VD1) (1998)
17.
Of the two sending units in the kit, choose the one with the connector that matches the connector from the old sending unit.
18.
Install the new sending unit:
19.
Reinstall the original float arm by pushing on its pivot point to clip it into place. After installation, make sure the arm moves freely under its own
weight. If it doesn't, the pivot point is bent, and the sending unit won't show the correct fuel level. To correct a bent pivot point, remove the arm,
bend the pivot point back to its original 90° position, and reinstall the arm.