Passport EX 2WD V6-3.2L SOHC (6VD1) (1997)
/Page-2226004.png)
14. Bracket
15. Speaker box
^
Remove 3 fixing bolts.
16. Water-proof sheet
^
Take care not to damage the sheet when peeling it off.
17. Window glass
^
Remove 2 screws through the access hole and pull out the window glass upward.
18. Window regulator / Power window motor
^
Disconnect the power window motor connector.
19. Glass run
^
Pull it out of the door pillar of the channel (front/rear).
20. Glass run rear channel
^
Remove 2 screws.
21. Inside lever
22. Door lock assembly / Door lock actuator
^
Disconnect the linkage with the outside handle, the inside lever and the lock cylinder.
23. Glass run front channel
24. Door lock cylinder
25. Outside handle
INSTALLATION
To install follow the removal steps in the reverse order noting the following points.
1. Connect securely the connector of the power window motor and then wind a soft tape around the connector.
