Passport EX 2WD V6-3.2L SOHC (6VD1) (1997)
Brake Pedal Assy: Service and Repair
PREPARATION
-
Disconnect the battery "-" terminal cable, and wait at least 5 minutes.
-
Disconnect the yellow 3 way SRS connector located under the steering column.
Brake Pedal Replacement
REMOVE
1. Instrument panel lower cover
-
Remove the engine hood opening lever.
2. Lower cluster
3. Meter cluster
4. Driver knee bolster
-
Remove the steering column shaft fixing bolts on the steering wheel side, and lower the steering column shaft.
5. Vent duct
6. Connector
-
Disconnect the stop light switch connector.
-
Disconnect the anti-theft control module connector.
7. Snap pin
8. Push rod pin
9. Bolts
10. Brake pedal bracket assembly
-
Remove the brake pedal bracket assembly.
11. Return spring
12. Fulcrum pin
13. Pedal assembly
INSTALL
1. Pedal assembly
2. Fulcrum pin
-
Apply grease to the entire circumference of the fulcrum pin.
Spec
Torque to 35 Nm (26 lb. ft.)