Passport EX 2WD V6-3.2L SOHC (6VD1) (1997)
ASSEMBLY
1. Rocker arm [7]
-
Apply a light coat of engine oil to the rocker arm shafts.
-
Rocker arm shafts are different, so care should be taken when reinstalling rocker shafts.
-
All rocker arms on rocker shaft inlet should be installed in the same direction.
-
Install a wave washer between rocker arm inlet and rocker arm exhaust.
2. Rocker shaft assembly (Intake side) [6]
-
Tighten rocker shafts bolts in sequence shown in illustration to 18 Nm (13 ft. lbs.).
3. Rocker shaft assembly (Exhaust side) [5]
-
Tighten rocker shaft bolts in sequence shown in illustration to 18 Nm (13 ft. lbs.).
NOTE: When installing the rocker shaft assembly to the cylinder head, both of the rocker arm ends should be contacted with each other as shown.
4. Camshaft [4]
5. Camshaft bracket housing fixing bolts [3]
6. Front plate [2]
7. Camshaft timing pulley [1]