Passport EX 2WD V6-3.2L SOHC (6VD1) (1997)
Oil Filter: Service and Repair
REMOVAL
NOTE: Before starting, remove the battery ground cable
1. Oil filter
-
Remove using the filter wrench J-36390, or equivalent.
-
After installation of oil filter, check oil cooler fixing center bolt for looseness.
INSTALLATION
1. Oil filter [1]
-
Clean filter fitting surface and apply small amount of oil to sealing surface of packing so that filter can be fitted tightly.
NOTE:
-
Make sure that the packing sealing surface is properly fit to the oil cooler sealing surface.
-
Rotate oil filter until oil cooler sealing surface comes in contact with gasket, then rotate additional 2/3 turn to tighten using filter wrench
J-36390, or equivalent.