honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Engine - High or Erratic Idle|Page 2614 > < Engine - High or Erratic Idle|Page 2612
Page 5
background image

Detect Code:

064

Contention Code:

C01

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.

Cracked Intake Manifold Gasket

1.

Refer to service bulletin 00-010, Rough Idle and/or DTCs P0171, P0174, or P1171, filed under Fuel and Emissions for the repair procedure and
parts information.

2.

Use the Smart Cable to reprogram the PCM with the latest software from the June 2000 or later Hondanet CD-ROM. Refer to service bulletin
99-005, Updating the Passport PCM, filed under Tools.

3.

Use the PGM Tester to clear any DTCs.

4.

Use the PGM Tester to check the broadcast code. Make sure the broadcast code matches the one you selected from the CD-ROM.

WARRANTY CLAIM INFORMATION

In warranty: 
The normal warranty applies.

Failed Part:

P/N 8-97131-894-2 
H/C 5510771

Defect Code:

017

Contention Code:

C99

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.

Engine/Body Ground

1.

Use the ETM for the appropriate year to locate these ground connectors:

1996-97: G101, G102, G104, G106, G107, G108, G114, G115, G116, and G117.

1998-99: G101, G102, G103, G104, G105, and G106.

2.

Inspect each connector for corrosion or looseness.

3.

Remove the bolt from any connector that is corroded or loose. Clean the terminal connector with a wire brush. File flat any solder bumps on the
connector.

4.

Clean the contact surface on the engine or body with a wire brush.

5.

Replace the bolt if it is heavily corroded. Otherwise, clean it with a wire brush.

6.

Apply lithium dielectric grease to both sides of the terminal connector.

7.

Reinstall the bolt, torque it to 14 N.m (10 lb-ft).

Engine - High or Erratic Idle|Page 2614 > < Engine - High or Erratic Idle|Page 2612