Passport EX 2WD V6-3.2L SOHC (6VD1) (1997)
/Page-1974002.png)
-
Inspect the lower end boot for damage or grease leak. Move the ball joint as shown in the figure to confirm its normal movement.
-
Inspect the screw/taper area of ball for flaws. If any defects are found by the above inspections, replace the ball joint assembly with new one.
After moving the ball joint 4 or 5 times, attach nut the measure the preload. The starting torque should be 0.5 - 6.4 Nm (0.4 - 4.7 inch).
-
If the above limits specified are exceeded, replace the ball joint assembly.
