Passport EX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-1489001.png)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir, Removal / Installation
REMOVAL
NOTE: Before removing the fluid reservoir, remove the brake fluid from the fluid reservoir.
1. Disconnect electrical connector.
2. Remove retainer (1).
3. Remove fluid reservoir and the fluid level sensor built into the fluid reservoir. The fluid level sensor cannot be removed for servicing.
4. Remove O-ring.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
