Passport EX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-582003.png)
identify it.)
3.
Connect the PC adapter end of the PC interface kit to the 9P serial port on the DCS workstation.
NOTES:
It the workstation you're using isn't the same one used for updating PGM Tester program cards, you'll need to disconnect the interface kit from one
workstation, and then connect it to the 9P serial port on the other workstation. To avoid this extra step, get a PC interface kit for each workstation.
4.
Connect the 110 VAC/12 VAC power supply to the Smart Cable box and to 110 VAC power.
5.
Log in to HONDANET 2000.
6.
At the top of the HONDANET 2000 screen, click on Service Bay, then click on Smart Cable from the drop-down menu. This brings up the Smart
Cable Welcome screen.
7.
Retrieve the PCM broadcast code with the Smart Cable or the PGM Tester.
^
To retrieve the code with the Smart Cable, go to step 8.
^
To retrieve the code with the PGM Tester, go to step 14.
8.
From the Smart Cable Welcome screen, click on Get ID. When the "Smart Cable is programmed to Get ID" message appears, disconnect the cable
from the workstation.*
9.
*Disconnect the Smart Cable from the DCS workstation, then take it to the vehicle. Turn the ignition switch ON (II), and connect the Smart Cable
to the vehicle's DLC.
10.
When the green and yellow lights on the Smart Cable glow steadily, disconnect it from the DLC.
11.
Reconnect the Smart Cable to the DCS workstation (steps 2 thru 4 above).
12.
From the Smart Cable Welcome screen, click on View ID. The broadcast code needed by the PCM will be highlighted.
13.
Click on the highlighted broadcast code, and follow the instructions to reprogram the Smart Cable with the broadcast code needed for the PCM
update. When the Smart Cable has been reprogrammed, go to step 21.
14.
Connect the Tester to the vehicle's DLC, then turn the ignition switch ON (II).
15.
From the System Select menu, press 1: ENGINE
16.
From the Test Mode menu, press 6: MISC TEST
17.
From the MISC TEST menu, press 6: BROADCAST CODE
18.
Write down the 4-digit broadcast code; you'll need it to reprogram the Smart Cable.
19.
Write down the 4-digit broadcast code; you'll need it to reprogram the Smart Cable.
20.
Go back to the DOS workstation. From the Smart Cable Welcome menu, click on Select.
21.
Follow the instructions to reprogram the Smart Cable with the broadcast code needed for the PCM update.
22.
Now that the Smart Cable is programmed to update the PCM, go to USING A PROGRAMMED SMART CABLE.*
