Passport EX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-681003.png)
11.
Using a jumper wire, connect the reference voltage of each circuit to its signal input and view the APP Sensor values in the Engine Data List. APP
Sensor 1 should have a value of 99%, and APP Sensor 2 and APP Sensor 3 should each have a value of 0%.
^
If the values are not as specified, troubleshoot for high resistance on the signal input or a PCM malfunction. Repair the circuit or replace the
PCM, then repeat step 3.
^
If the values are as specified, the problem may be intermittent. Disconnect the 10P connector from the modified APPS, and connect it to the
new APPS; then repeat step 3. Wiggle the APPS wires as you go through the adjustment procedure to find the intermittent problem.
12.
Turn off the ignition switch, and disconnect the PGM Tester.*
DISCLAIMER
