Passport EX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-1637002.png)
REASSEMBLY
1. Install mounting rubber and dust cover (If removed).
2. Install oil line. Torque to 13 Nm (113 inch lbs.)
3. Install tie-rod assembly with tab washer. Apply grease to ball joint, install tie-rod and tab washer, then tighten to specified torque. Torque to 83
Nm (61 ft. lbs.).
After tightening, bend tab washer against width across flat of inner ball joint.
4. Apply a thin coat of grease to the shaft for smooth installation. Then install bellows.
5. Install band and clip.
6. Install tie-rod end and tighten lock nut. Torque to 98 Nm (72 ft. lbs.)
