Passport LX 2WD V6-32L DOHC (6VD1) Engine Mount Vibration Issue
2.
Loosen the two flange nuts holding the transmission mount to the third crossmember.
3.
Use a pry bar to shift the engine assembly all the way forward.
4.
Hold the prybar in place, and torque the flange nuts to 50 N.m (37 lb-ft).
5.
Lower the vehicle.
6.
Start the engine, and check for vibration. Make sure the chassis is not touching the lift during this check.
^
If the vibration is gone, no further action is required.
^
If the vibration is still there, go to REPAIR PROCEDURE B.
REPAIR PROCEDURE B
1.
Write down your customer's radio station presets and mode settings.
2.
Disconnect the negative cable from the battery.
3.
Raise the vehicle on a lift.
4.
Remove both front wheels.
5.
Models With 4WD: Remove the front skid plate (four bolts, four lock washers, four washers).