Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
Seat Back: Service and Repair
Rear Seat Back Assembly And Associated Parts LWB)
Removal
1. Pull the release knob and pull the seat back assembly forward.
2. Remove the luggage floor carpets.
-
Pull the nine carpet fixing clips from the backside of the seat back assembly.
3. Remove the seat back assembly.
-
Remove the four fixing bolts at each seat back.
4. Remove the seat lock covers.
5. Remove the headrests.
6. Remove the release knobs.
-
Turn the knob counterclockwise to remove it.
7. Remove the trim covers.
8. Remove the guide holders.
9. Remove the side hinges.
-
Remove the one fixing nut at each side hinge.
10. Remove the center hinge.
-
Remove the two fixing belts.
Installation
To install, follow the removal steps in the reverse order noting the following points:
1. Tighten the center hinge fixing bolts to the specified torque.