Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
-
Align the located portion (1) of the field coil and compressor.
-
Tighten the mounting screw to the specified torque
Torque: 5 Nm (44 lb in)
2. Connect the lead wire connector with the rubber hold and tighten the screw.
3. Install pulley assembly by using pulley installer J-33940-A (2) and drive handle J-8092 (1).
4. Install snap ring.
5. Install shim (s).
6. Install the drive plate to the compressor drive shaft together with the original shim(s)(1). Press the drive plate by hand.