Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-1649004.png)
4. Fit the top of the shock absorber rod in the connection part of the actuator.
NOTE: The mating section is width fitting across flats.
5. If these normally fit, the distance between the actuator lower face and the bracket upper face is about 1 mm.
6. Install 2 screws then tighten it to the specified torque.
Torque: 3 Nm (26 in. lbs.)
7. Connect the connector to the harness and insert the connector to the bracket.
8. Connect the actuator harness with the clip.
9. Connect the battery ground cable.
