Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-1662029.png)
42. Reinstall both lower trailing links with new front mounting nuts and bolts. Hand-tighten the nuts.
43. Remove the ratcheting straps.
44. Lower the vehicle to the ground.
45. Carefully raise the rear of the body off the frame using the method you chose earlier in the repair, then remove the wood blocks.
46. With the body still raised off the frame, reinstall the No. 5 body mounts, and torque the bolts to 50 Nm (37 Ib-ft).
47. Spray some Noxudol 300 around the No. 4 body mount locations.
48. Carefully lower the body onto the frame, then torque the body mount nuts and bolts to 50 Nm (37 Ib-ft).
49. Torque the lower trailing link front mounting bolts to 165-180 Nm (122-133 Ib-ft).
50. Raise the vehicle, then reattach the EVAP canister line to the bulkhead (three clips).
51. Loosen the bracket bolts and clip from both front fenderwells. Reattach the ABS speed sensor harness clips in the front fenderwells, then torque the
ABS speed sensor harness bracket bolts to 11 Nm (8 Ib-ft). Reconnect the ABS speed sensor harnesses.
52. Reattach the brake lines to the passenger's side of the frame using the four new clips from the kit.
53. Reattach the wire harness along the driver's side of the frame using the six new clips from the kit.
54. Reinstall the parking brake cable mounting brackets on both sides of the frame using the four new bolts from the kit. Torque the bolts to 7 Nm (5
Ib-ft).
55. Reinstall the fuel tank assembly using the new mounting bolts, the nut, and the clips from the kit. Torque the mounting bolts and the nut to 68 Nm
(50 Ib-ft).
56. Reinstall the exhaust silencer (muffler) with a new gasket and new nuts. Torque the silencer nuts to 43 Nm (32 Ib-ft). Torque the silencer bracket
mounting nuts to 15 Nm (11 lb-ft).
57. Reinstall the rear bumper assembly. Torque the bumper mounting bolts to 147 Nm (108 Ib-ft)
58. Reinstall the linear EGR valve with a new gasket. Torque the bolts to 25 Nm (18 Ib-ft).
59. Reinstall the radiator grille.
60. If the side steps or the running boards were removed, reinstall them.
61. Fill out the information on a campaign completion label. Stick this label to the back edge of the driver's door, just below the door latch.
*NOTE:
