Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
9. Use wrench J-36827, remove hub nut.
10. Remove hub and disc assembly.
11. Remove ABS sensor ring.
12. Remove outer bearing.
13. Remove oil seal.
14. Remove inner bearing.
15. Remove bolt, if necessary, replace the wheel pin in the following manner.
-
Apply a scribe mark (1) to disc to hub.
-
Clamp the hub and disc assembly in a vise, using protective pads. Remove the 6 disc-to-hub retaining bolts.
-
Place hub on a suitable work surface and remove the studs by using a hammer.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the
following parts.
-
Hub
-
Hub bearing oil seal
-
Knuckle spindle