Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
HEC ENGINE
6VD1 ENGINE
Installation
1. Perform vacuum booster and vacuum booster push rod adjustment.
NOTE: When replacing either the master cylinder or vacuum booster, be sure to measure push rod, and adjust if required.
2. Remove retainer from vacuum booster front shell using a small screwdriver. Then gently draw plate and seal assembly out of the shell inside.
3. Set push rod gauge J-39216 on vacuum booster, and apply negative pressure by means of vacuum pump J-23738-A so that the pressure in the
vacuum booster becomes 500 mm Hg.
NOTE: Be sure to apply NEGATIVE pressure after installing a push rod gauge on the vacuum booster.
