Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
2. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
3. Align the setting marks made when removing then install steering wheel.
CAUTION: Never apply force to the steering wheel shaft using a hammer or other impact tools in an attempt to remove the steering wheel. The
steering shaft is designed as an energy absorbing unit.
4. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
5. Support the inflator module and carefully connect the SRS connector and horn lead.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
6. Tighten bolts to specified torque.
Torque: 9 Nm (78 inch lbs.)
7. Install driver knee bolster (reinforcement).
8. Install instrument panel lower cover then Install the engine hood opening lever.
9. Connect the SRS connector.
10. Connect the battery "-" terminal cable.
11. Turn the ignition switch to the "ON" position and observe the warning lamp.
