Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
8. Install hub nut.
Turn to the place where there is a chamfer in the tapped hole to the outer side, then attach the nut by using front hub nut wrench J-36827.
Preload Adjustment
1. Tighten the hub nut to 29 Nm (22 ft. lbs.), then fully loosen the nut.
2. Tighten the hub nut to the value given, using a spring scale on the wheel pin.
New bearing and New oil seal
Bearing Preload: 20 N - 25 N (4.4 lbs. - 5.5 lbs.)
Used bearing and New oil seal
Bearing Preload: 12 N - 18 N (2.6 lb - 4.0 lbs.)
If the measured bearing preload is outside the specifications, adjust it by loosening or tightening the bearing nut.
9. Install lock washer and lock screw in the following manner.
-
Turn the side with larger diameter of the tapered bore to the vehicle outer side, then attach the washer.
-
If the bolt holes in the lock plate are not aligned with the corresponding holes in the nut, reverse the lock plate.
-
If the bolt holes are still out of alignment, turn in the nut just enough to obtain alignment.
-
Screw is to be fastened tightly so its head may come lower than the surface of the washer.
10. Apply adhesive (LOCTITE 515 or equivalent) to both joining flange faces then install hub flange.
