Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
CAUTION: Turn the SRS coil counter clockwise until some resistance is felt, or damage may occur to the SRS coil.
7. When installing the steering column cover, be sure to wire (through each harness) as illustrated so that the harnesses starter switch, combination
switch and SRS coil may not catch wiring.
8.
Install steering wheel by aligning the setting marks made during removal.
CAUTION: Never apply force to the steering wheel shaft using a hammer or other impact tools in an attempt to remove the steering wheel. The
steering shaft is designed as an energy absorbing unit.
9. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
10. Support inflator module and carefully connect the SRS connector and horn lead, then install inflator module.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
11. Tighten fixing bolts to specified torque.
Torque: 9 Nm (78 inch lbs.)
12. Install driver knee bolster (reinforcement).
13. Install instrument panel lower cover, then install the engine hood opening lever.
14. Connect the yellow 2-way SRS connector located under the steering column.
15. Connect the battery ground cable.
