Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Shift Solenoid: Service and Repair
Removal
1. Raise the vehicle and support it on jack stands.
2. Disconnect battery ground cable.
3. Drain fluid.
4. Remove sixteen 10 mm screws, main case oil pan, magnet, and gasket.
5. Remove three 13 mm screws, oil filter.
6. Disconnect wiring harness from band control solenoid and shift solenoids. Pull only on connectors, not on wiring harness.
7. Remove spring pin for shift solenoid A, shift solenoid B, and band control solenoid respectively, using suitable pliers taking care not to damage
solenoids.
8. Remove shift solenoid A, shift solenoid B, band control solenoid, and gaskets from main case valve body. Do not pull on wiring harness.
Remove solenoids by grasping the metal tip.
Installation
1. Install shift solenoid A, shift solenoid B, band control solenoid with new gaskets to main case valve body respectively.