Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Front Seat Belt And Associated Parts
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the sill plate (Front & Rear).
3. Remove the anchor cover and seat belt lower anchor bolt.
4. Remove the lower center pillar trim cover.
5. Remove the door seal finisher (Front & Rear).
6. Remove the upper center pillar trim cover.
7. Remove the seat belt upper anchor bolt.
8. Remove the retractor fixing bolt.
9. Remove the seat belt assembly.
10. Remove the adjustable shoulder anchor assembly.
-
Remove the two fixing bolts.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points.
CAUTION: When replacing the front seat belt, always replace the seat belt with the same parts/part number.
1. Tighten the adjustable shoulder anchor assembly fixing bolts to the specified torque.
Torque: 39 N.m (29 lb.ft)
2. Tighten the seat belt anchor bolts (Upper & Lower) and the retractor fixing bolts to the specified torque.
Torque: 39 N.m (29 lb.ft)
Removable Top
