Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
4. Install adjust body of cable assembly to bracket in selector lever assembly.
Install inner cable to lever, pulling inner cable with outer cable.
5. Check that cable moves smoothly, lightly pulling outer cable rearward.
6. Connect lock adjust, aligning "T" mark in the "Up" position.
7. About following installation steps, refer to Selector Lever.
8. Check the shift lock operation:
a. Selector lever should not be moved out of "P" position with ignition key in "Lock" position.
b. Selector lever can be moved out of "P" position with ignition key in "ON" position only when brake pedal is depressed.
c. ignition key can be turned to "LOCK" position only when selector lever is in "P" position (key can be pulled out).
9. If a. and c. fail, readjust cable. If b. fails, readjust connector wiring and brake pedal switch.
