Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
4. Remove flange nut by using pinion flange holder J-8614-01.
5. Remove flange.
6. Remove oil seal.
7. Remove outer bearing by using remover J-39602.
8. Remove collapsible spacer.
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the
following parts.
1. Seal surface of the pinion.
2. Cage bore for burns.
Installation
1. Install collapsible spacer. Discard the used collapsible spacer and install a new one.
2. Install outer bearing.
NOTE: Do not drive in, but just temporarily set in the outer bearing by hand, which should be indirectly pressed in finally by tightening the
flange nut.
