Pilot V6-3.5L (2004)
-
Sand the damaged area flat and smooth.
Use a disc sander and #6O~#8O disc sandpaper
Use the double action sander and #6O~#8O disc paper.
-
Sand the area larger than the damaged area.
Use a double action sander and #18O~#24O disc sandpaper.
-
If a double action sander is not available, use a rubber pad and wet or dry sandpaper.
Use a flexible block and #280, #340, #400, #600 sandpaper.
Damage to undercoat, intermediate coat and top coat:
Sand the damage area flat and smooth
Use a double action sander and #180~#240~#320 disc sandpaper.
2. Preparing metal surfaces.
Remove all corrosion from the damaged area.
Use a product that removes corrosion.
3. Air blowing / degreasing
Use alcohol, and wax, and grease remover.
Treatment of Metal Surface
Treatment of Metal Surface
1. Filling/drying
Small cracks or pinholes in the sheet metal should be repaired with a body filler and sanded flat and smooth.
-
Use a 2-part polyester resin putty.
-
Mix the putty with the hardener in the correct ratio.
-
Follow the body filler manufacturer's instructions.
