Pilot V6-3.5L (2004)
Shallow Scratch:
Use a flexible block and #24O~#4OO~#6OO sand paper.
Hole / Deep Gouge:
Cut out and flatten any torn or burred area.
Use a knife, flexible block, and #18O~#24O sand paper.
2. Air blowing / degreasing
Clean the damaged area thoroughly.
Use alcohol, and wax and grease remover.
Undercoating
Undercoating
1. Spraying primer
Primer is used to fill cavities in the putty and primer surfacer.
-
Spray primer on the exposed area.
-
Spray 2 to 3 coats of primer over the area where you applied putty.
-
Supply primer to the back of the bumper if the damage is a tear or hole.
