Pilot V6-3.5L (2004)
Radiator Cooling Fan Temperature Sensor / Switch: Service and Repair
Radiator Fan Switch C Replacement
Replacement
Special Tools Required
Sensor socket wrench 07KAA-PP80100
1. Make sure you have the anti-theft codes for the radio and navigation system, then write down the frequencies for the radio's preset buttons.
2. Disconnect the negative cable from the battery first, and then the positive cable, and remove the battery.
3. Drain the engine coolant.
4. Disconnect radiator fan switch C connector (A), and remove the harness clamp (B), then loosen the radiator fan switch C with the special tool (C).
5. Remove radiator fan switch C (A).
6. Install radiator fan switch C with a new O-ring (B).
7. Fill the radiator with engine coolant and bleed the air.
8. Install the battery. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
9. Perform the powertrain control module (PCM) idle learn procedure, and power window control unit reset procedure.
10. Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets, and reset the clock.
