Pilot V6-3.5L (2004)
Front Crankshaft Seal: Service and Repair
Pulley End Crankshaft Oil Seal Installation - In Car
Special Tools Required
-
Oil seal driver, 64 mm 070AD-RCAA100
1. Clean and dry the crankshaft oil seal housing.
2. Apply a light coat of multi-purpose grease to the crankshaft and to the lip of the seal.
3. Using the special tool, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess
grease off the crankshaft, and check that the oil seal lip is not distorted.