Pilot V6-3.5L (2004)
Air Bag Control Module: Service and Repair
OPDS Unit Replacement
OPDS Unit Replacement
NOTES:
-
Review the seat replacement procedures in the Body section before doing repairs or service.
-
Refer to TSB Number 02-052 for additional information on the ODPS initialization procedure.
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the passenger's side airbag harness 2P connector.
3. Remove the front passenger's seat assembly and seat-back cover.
4. Remove the cover (A), then disconnect the OPDS unit harness 8P and sensor connectors (1) from the OPDS unit.
5. Remove the three screws (B) and the OPDS unit (C).
Installation
1. Place the new OPDS unit (A) on the seat-back frame Tighten the three screws (B), and connect the OPDS unit harness 8P and sensor connectors to
the OPDS unit Reinstall the cover (C).
2. Install the seat-back cover.
3. Install the seat assembly, then connect the side airbag harness 2P connector.
4. Reconnect the battery negative cable.
5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
6. Initialize the OPDS unit.
7. After installing the OPDS unit, confirm proper system operation: Turn the ignition switch ON (II), the SRS indicator should come on for about 6
seconds and then go off.
