Pilot V6-3.5L (2004)
Power Door Lock Switch: Testing and Inspection
Door Lock Switch Test
Door Lock Switch Test
1. Remove the door panel.
2. Remove the two screws, then remove the door lock switch.
3. Check for continuity between the terminals.
-
There should be continuity between the No. 1 and No. 2 terminals when the door lock switch is in the LOCK position.
-
There should be no continuity between the No. 1 and No. 2 terminals when the door lock switch is in the neutral position.
-
There should be continuity between the No. 2 and No. 3 terminals when the door lock switch is in the UNLOCK position.
-
There should be no continuity between the No. 2. and No. 3 terminals when the door lock switch is in the neutral position.
-
Except LX: There should be continuity between the No. 5 (+) and No. 4 (-) terminals under all condition.
4. If the continuity is not as specified, replace the switch.
