Pilot V6-3.5L (2004)
9. At the harness side, connect PSP switch 2P connector terminals No.1 and No.2 with a jumper wire.
10. Measure voltage between PCM connector terminals A26 and B20.
Is there less than 1.0 V ?
YES - Replace the PSP switch.
NO - Check for an open in the wire between the PCM (A26) and the PSP switch or, an open in wire between the PSP switch and G201.
11. Turn the ignition switch OFF.
12. Disconnect the PSP switch 2P connector.
13. Turn the ignition switch ON (II).
14. Measure voltage between PCM connector terminals A26 and B20.
Is there battery voltage?
YES - Replace the PSP switch.
NO - Go to step 15.
15. Turn the ignition switch OFF.
16. Disconnect PCM connector A (32P).
