Pilot V6-3.5L (2004)
19. Press the wheel bearing (A) out of the knuckle (B) using the special tools and a press.
20. Press the wheel bearing inner race (A) from the hub (B) using the special tool, a commercially available bearing separator (C), and a press.
21. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
22. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tool, and a press. Be careful not to
damage the sleeve of the pack seal.
23. Install the snap ring (A) securely in the knuckle (B).
