Pilot V6-3.5L (2004)
15. Remove the flange bolts (A), and separate the knuckle from the trailing arm (B).
16. Place a floor jack under lower arm B. Remove the self-locking nut (A), washer, and flange bolt (C).
17. Remove the knuckle while pushing in the driveshaft and holding the driveshaft outboard joint.
18. Separate the hub (A) from the knuckle (B) using the special tool and a hydraulic press. Be careful not to deform the splash guard. Hold onto the
hub to keep it from falling when pressed clear.
19. Remove the flange nuts (A), backing plate (B), and snap ring (C).
