Pilot V6-3.5L (2004)
6. Pack the inboard joint with the joint grease included in the new driveshaft set.
Grease quantity
Inboard joint: 130 - 140 g (4.6 - 4.9 oz)
7. Fit the inboard joint onto the driveshaft, and note these items:
^
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
^
Hold the driveshaft so the inboard joint points up to prevent it from falling off.
8. Adjust the length of the driveshafts to the figure, then adjust the boots to halfway between full compression and full extension. Make sure the ends
of the boots seat in the grooves of the driveshaft and joint.
Left driveshaft: 574 - 579 mm (22.6 - 22.8 inch)
Right driveshaft: 603 - 608 mm (23.7 - 23.9 inch)
9. Install the boot bands.
^
For the double loop type, go to step 13. (Boot band replace only)
^
For the low profile type, go to step 10.
