Pilot V6-3.5L (2004)
25. Install the hub (A) on the knuckle (B) using the special tools and a hydraulic press. Be careful not to deform the splash guard (C).
26. Install the knuckle in the reverse order of removal, and note these items:
-
Be careful not to damage the ball joint boot when installing the knuckle.
-
Place a jack under the lower arm, and raise the lower arm to load the suspension with the vehicle's weight.
-
Tighten all mounting hardware to the specified torque values.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the castle
nut by loosening it.
-
Install a new clip on the castle nut after torquing.
-
Use a new spindle nut on reassembly.
-
Before installing the new spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake
the spindle nut shoulder against the driveshaft.
-
Before installing the brake disc/drum, clean the mating surfaces of the rear hub and the inside of the brake disc/drum.
-
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
-
Check the rear wheel alignment, and adjust it if necessary.
